Drop audio (WAV/AIFF/FLAC/OGG/MP3) or a folder of samples here — nameless sets auto-map by pitch, and subfolders become velocity layers. Also .SLI/.SLC and .SF2 SoundFonts. Click to browse.
With a set already loaded, opening an .SLI/.SLC lets you add it to build a collection (.SLC) instead of replacing. Name hints auto-place samples: rC3 root · k48-52 key range · v90 or v0-64 velocity (e.g. Rhodes_rC3_v90.wav).
New here? Six sampled notes across the keyboard — play it with the on-screen keys or a MIDI keyboard, then edit the zones to see how it's put together.
Instruments
Selected instrument
Zones
Health check
Batch loops
Auto-tune
Selected zone —
| Sample | Ch | Rate | Frames | Root | Fine | Key lo | Key hi | Vel lo | Vel hi |
|---|
Edit —
Sampler
Build an instrument by sampling — Auto drives a MIDI device and captures note by note; Manual captures sounds you play into a mic (percussion, FX, voice). Chrome/Edge over localhost.
Devices & level
Same syntax as device prep: one message per line, CC91=0 on the run channel or raw hex like F0 41 10 … F7. Nothing is sent automatically — use this to put the device into the state you want before monitoring or capturing.
What to sample
Capture tuning — defaults are usually fine
Run
Batch preset sweep — sample a whole bank unattended
One preset per line: an address (program, msb.program, or msb.lsb.program) then an optional name. # comments and blank lines are ignored. Each preset is captured with the note range / velocities above and added as its own instrument — then multi-select in the Instruments tab to export.
Device prep — neutralise settings that hurt sampling. One message per line: CC91=0 (Control Change on the run channel) or raw hex like F0 41 10 … F7 (SysEx). Prep is re-sent after every program change because patches reload their own FX; setup is sent once at the start.
Manual capture
Single sound captures a one-shot at increasing strengths (percussion/FX/voice). Multi-sample walks a note range and prompts each note note-by-note (mic'd guitar, real piano) — sustained notes get an auto loop. For each strength, play so a peak lands in the green target band on the meter; it re-asks until you're in, then moves on (stereo passes if either channel is in the band). Set gain with Monitor first, and stay quiet during the brief noise-floor calibration.